
A burst pipe upstairs is a mess. A burst pipe in the basement is a race — against the sump, the storage boxes, the furnace, and the clock. This checklist is the order that matters for Brighton basements, finished and unfinished, in the first sixty minutes.
Water off (minute 0–5)
Main valve closed. If the burst is a basement pipe, this alone stops the flood.
Power check (minute 5–10)
Breaker panel is often in the basement. If it is dry, switch off circuits feeding wet areas. If it is wet, stay away from it entirely.
Drainage (minute 10–15)
Is the sump pump running? Is the floor drain clear? These two decide how deep it gets while you work.
Triage & photos (minute 15–60)
Photograph the room as found, then move belongings in the priority order below.
| Unfinished basement | Finished basement | |
|---|---|---|
| Biggest risk | Stored belongings, furnace and water heater exposure | Carpet, pad, drywall, and built-ins soaking up water from below |
| First move after shutoff | Sweep water toward the floor drain; lift boxes onto pallets or shelves | Start extraction fast — carpet pad holds water against the subfloor and wall bases |
| Drying window | Concrete forgives a slower dry-out | Mold can start in 24–48 hours inside wall bases and under pad — professional drying matters |
| Insurance note | Photograph stored items in place | Photograph finishes before anything is pulled up; keep a carpet/drywall sample if the insurer asks |
Many Brighton homes — especially in newer subdivisions — have finished or partially finished basements with a bathroom tucked into the corner. That bathroom’s supply lines, running through the basement ceiling and exterior walls, are also among the most freeze-prone pipes in the house (see the prevention checklist).
A working sump pump with a clear discharge line can remove thousands of gallons while you triage. Check three things: it is plugged in and running, the float moves freely, and the discharge outside is not frozen or blocked — a February problem in Brighton more often than people expect. If the pump has failed and water is rising, that fact changes the call you make: say so when you call (720) 918-0220, because water removal becomes step one, ahead of the pipe repair itself. And never run a generator or gas pump inside the basement to move water — carbon monoxide kills faster than flooding does.
For the whole-home version of this sequence, our flooding damage control guide covers documentation and insurance in depth, and the water damage cleanup page explains what professional drying actually involves. Brighton Burst Pipe is a referral service: one call connects you with an independent local provider who can repair the pipe and start the dry-out — the call costs nothing.
Shut off the main water valve — in many Brighton homes it is in the basement near the front foundation wall. Then check power safety, confirm the sump pump and floor drain are moving water out, photograph everything, and start lifting belongings off the floor.
Most commonly where the water line enters through the front foundation wall, with the meter nearby — often in a utility area. Our shutoff guide walks through finding and testing it before an emergency.
Check it is plugged in and the float is free, and that the outside discharge is not frozen or blocked. If it has failed, treat rising water as the priority: move belongings first and tell the provider when you call, because extraction comes before repair.
Mold can begin within 24 to 48 hours on wet carpet pad, drywall, and insulation. A finished basement that is not professionally dried within the first day or two commonly turns a pipe repair into a mold remediation as well.
Photograph everything first. Small areas can be lifted to check the pad, but large-scale removal is usually part of professional extraction — and insurers may want to see conditions as found. When in doubt, document, extract surface water, and wait for the assessment.
Yes, if water reaches them — which is common, since they usually share the basement. Do not relight or restart flooded appliances until they have been checked; water in controls and burners is a safety issue, not just a repair bill.
Call and we will connect you with an independent local provider in the Brighton area who can stop the water and start the dry-out — the call itself costs nothing.