24/7 Emergency Service — Brighton, COCall (720) 918-0220
24/7 Emergency Service — Brighton, COCall (720) 918-0220
Photo of frost patterns on a window pane in winter

Privacy|Terms|Disclaimer
EMERGENCY BURST PIPE REPAIR — BRIGHTON, CO
CALL NOW

Emergency Guide • Brighton, CO • Updated October 2026

Pipe Freezing? What to Do Right Now, Before It Bursts

A frozen pipe is an emergency on a timer. Ice expands, pressure builds behind the blockage, and the split often happens while the pipe thaws — not while it freezes. Here is exactly what to do tonight: spot the freeze, thaw it safely, and know when to shut the water off first.

Call (720) 918-0220

Photo of frost patterns on a window pane in winter

Quick answer: Open the faucet fed by the frozen pipe first — this relieves pressure and lets melting water escape. Then apply gentle heat with a hair dryer, heating pad, or warm towels, working from the faucet back toward the frozen section. Never use a torch or open flame. If water is already leaking or the pipe looks split, shut off your main valve and call (720) 918-0220.

How Do I Know If a Pipe Is Frozen — or Just Low Pressure?

Here is a quotable fact: pipes can begin to freeze whenever temperatures hover around 32°F, especially in uninsulated runs along exterior walls, in crawl spaces, and in unheated garages. Brighton’s first freezes arrive in October, and the pipes most at risk are the ones you never see. The warning signs of a freeze in progress:

  • One faucet runs dry or barely trickles while the rest of the house flows normally — the classic signature of a single frozen section.
  • Frost or condensation on an exposed pipe in the basement, crawl space, or garage.
  • Strange smells from a drain or faucet — ice can block venting and push odors back toward the fixture.
  • Gurgling or banging sounds when you open a tap, as water pushes against an ice blockage.
  • A bulging section of pipe — ice expansion deforming the wall of the pipe. Treat this as a split waiting to happen.

Low pressure everywhere in the house is a different problem — that points to a supply or pressure issue, not a single freeze. If every faucet is dry, check with a neighbor first: if they have also lost water, the problem may be a water main break on the street, not your pipes at all. In that case there is nothing to thaw — the utility handles the repair.

The Freeze Night Protocol: 6 Steps Before the Temperature Drops Further

Freeze Night Protocol

1

Open the faucet. Turn on the tap fed by the suspect pipe — even a drip relieves pressure behind the ice.

2

Raise the heat. Keep the house at 55°F or warmer, all night — no thermostat setbacks during a freeze.

3

Open the cabinets. Kitchen and bathroom cabinets under sinks stay open so warm room air reaches the pipes.

4

Locate the freeze. Check exposed pipes in crawl spaces, garages, and exterior walls for frost or bulging.

5

Thaw gently. Hair dryer or heating pad, starting at the faucet and moving back toward the coldest section.

6

Know your shutoff. Keep a wrench by the main valve. If a split leaks, you shut it off in seconds — not minutes.

Going away during cold weather? The same protocol applies with one addition: have someone check the house daily, and never set the thermostat below 55°F while you are gone. The American Red Cross gives the same 55-degree floor for a reason — below it, pipes in exterior walls lose their safety margin.

Should I Turn Off the Water Before I Start Thawing?

Quick answer: If the pipe is only frozen — no leaks, no bulge, no visible split — leave the water on and open the faucet; flowing water helps the thaw and relieves pressure. If you see any leak, bulge, or crack, or you are not sure, shut off the main valve first. Thawing a split pipe with the water on turns a small leak into a flood the moment the ice lets go.

This is the step people get wrong in both directions. Shutting off the water unnecessarily does no harm, but skipping the shutoff when a pipe has already split is how a manageable problem becomes water damage. Remember what a freeze actually does: the ice expands and can crack the pipe, but the crack often stays sealed by the ice itself. The leak starts at thaw, not at freeze. So before you apply any heat, inspect the frozen section closely:

  • Is there frost only, or is there a visible crack, split seam, or bulge?
  • Is there any dampness, staining, or dripping below the pipe?
  • Does the pipe sit where a leak would go unnoticed for hours — inside a wall or above a ceiling?

If any answer worries you, shut the main off before thawing and place a bucket under the section. Our step-by-step guide to shutting off your main water valve takes about thirty seconds to follow. With the main off, you can thaw at your own pace with zero flood risk — then turn the water back on slowly and watch the section for leaks.

How Do I Thaw a Frozen Pipe Safely?

Work in this order: faucet open first, then heat applied to the pipe starting nearest the faucet and moving back toward the frozen section. That way melting water always has an escape route and steam pressure never builds up inside the pipe. Keep the faucet open the whole time — as the ice melts, flow increases from a drip to a stream, which tells you the blockage is clearing.

Method Safety Notes
Hair dryer Safest — gentle, controllable heat The first choice. Keep it moving along the pipe; do not park it on one spot. Slow but safe for all pipe types.
Heating pad / warm towels Safe — lowest heat of all Wrap the section and wait. Best for small, accessible sections and for plastic pipe, which dislikes direct heat.
Electric heat tape Safe when installed per instructions Designed for pipes. Wrap or run it along the frozen section and plug in. Also works as prevention on problem runs.
Portable space heater Use with caution Warms the whole area (crawl space, cabinet, garage corner). Keep it away from anything flammable and never leave it unattended.
Heat gun Risky — too hot, too fast Can boil water inside the pipe, warp plastic pipe, and scorch nearby wood. If it is your only option, use the lowest setting and keep it moving — or call a provider instead.
Torch / open flame Never The leading cause of freeze-related house fires. Flame near framing, insulation, or a gas line turns a plumbing problem into a structure fire. No exceptions.

The open-flame warning deserves its own emphasis: every winter, thawing attempts with propane torches and kerosene heaters start house fires. Beyond the fire risk, intense heat can boil the water trapped in the pipe, and the resulting steam pressure can split the pipe you were trying to save. Gentle heat feels slow. It is still faster than rebuilding.

How Long Does Thawing Take?

Anywhere from about 30 minutes for a short, exposed section in a basement to several hours for a long run inside a wall. Access is everything: a pipe you can touch thaws far faster than one you can only warm indirectly through drywall. If hours of indirect heat produce no drip at the faucet, the freeze may be longer than you think — or in a different place than you think. That is the point where professional thawing equipment earns its keep: see our frozen pipe thawing and repair service page for what a provider brings to the job.

What If the Pipe Already Split — and the Ice Is Holding the Water Back?

Quick answer: Assume the worst-case timing: the flood starts the moment the ice melts. Shut off the main valve before any thawing, put a bucket under the damaged section, and do not restore water until the split is repaired. If a leak is already running and you cannot find the valve, call (720) 918-0220 — we connect you with local providers who handle exactly this.

This scenario surprises people every freeze season: a pipe cracks overnight, nothing leaks because ice plugs the break, and the homeowner discovers the problem only when a warm afternoon thaws the plug and water pours out. If your inspection shows a split, bulge, or separated joint, your job is no longer thawing — it is containment:

  1. Shut off the main valve (see the shutoff guide if you have never done it).
  2. Drain the lines by opening faucets below the damaged section.
  3. Bucket and towels under the break to catch what melts out.
  4. Do not thaw the damaged section until a repair is planned — meltwater has nowhere good to go.
  5. Call (720) 918-0220 to get connected with a local provider for the repair itself.

And if the split has already let go — water actively spraying or pooling — skip straight to our burst-pipe emergency guide. If it happens in the middle of the night, the night and weekend protocol covers the order of calls to make.

How Do I Keep Pipes From Freezing Again Tonight?

Prevention matters because one freeze weakens a pipe for the next one. Another quotable fact: the high-danger zone is sustained cold at 20°F or below for six or more hours — long, deep cold gives ice time to form in even moderately protected runs. On nights heading that direction:

  • Let faucets drip — a pencil-thin stream or steady drip from faucets fed by exterior-wall pipes relieves pressure as ice forms, and pressure relief is what prevents the split.
  • Hold the thermostat at 55°F or above, day and night, per American Red Cross guidance — no overnight setbacks during a cold snap.
  • Open cabinet doors under sinks on exterior walls so heated room air circulates around the pipes.
  • Insulate exposed runs in crawl spaces, garages, and attics with foam pipe sleeves — cheap, and it buys hours of protection.
  • Seal drafts near pipes: cold air blowing directly on a pipe freezes it faster than still cold air.
  • Disconnect garden hoses and shut off exterior faucets from their inside valves before the season’s first freeze.

If the same pipe freezes every winter, it is telling you something about its route — it needs insulation, rerouting, or heat tape installed before the next cold snap. A provider can tell you which. Call (720) 918-0220 and we will connect you with a local provider who can assess it.

Frequently Asked Questions

How do I know if my pipe is frozen or if it is a water main break?

Check the pattern and check the neighbors. One dry faucet with the rest of the house working normally means a frozen section in your home. Every faucet dry — and neighbors reporting the same — points to a main break on the street, which the utility repairs. If only your house is affected everywhere, suspect the main line where it enters the home.

Should I turn off the water while thawing a frozen pipe?

If the pipe is intact, no — leave the water on, open the faucet, and thaw gently; flowing water helps clear the ice. If you see a crack, bulge, or any leak, shut off the main valve first. A split pipe leaks the moment the ice plug melts, and that moment should happen on your terms.

Is a heat gun safe to use on frozen pipes?

It is risky. A heat gun can get hot enough to boil water inside the pipe, warp plastic pipe, and scorch nearby framing. A hair dryer delivers enough heat for thawing with far more control. Never use a torch or any open flame — that is how thawing attempts turn into house fires.

How long does it take to thaw a frozen pipe?

About 30 minutes for a short exposed section, up to several hours for a long run hidden inside a wall, where heat reaches the pipe only indirectly. If steady work produces no drip at the open faucet after a few hours, the blockage may be longer or elsewhere — time to bring in a provider with professional thawing equipment.

What temperature should I keep my house at during a freeze?

At least 55°F, around the clock, following American Red Cross guidance. Skipping the nighttime thermostat setback during a cold snap is far cheaper than a burst pipe. Open cabinet doors under sinks on exterior walls so that warmth actually reaches the pipes.

The frozen pipe is inside a wall. What can I do?

Warm the wall, not the pipe: raise the room temperature, aim a space heater at the wall section from a safe distance, and open the faucet. Do not cut into drywall blindly — you do not know exactly where the pipe runs, and the split may need repair access anyway. If indirect heat fails, a provider can locate the freeze and open the wall precisely; see our frozen pipe thawing and repair page.

Service-area map: Brighton and nearby communities. Shown for orientation only; we have no physical office address.

Pipe frozen — or already split?

Do not wait for the thaw to decide for you. Call now and we will connect you with an independent local provider in the Brighton area — the call itself costs nothing.

Call (720) 918-0220 now

Call (720) 918-0220

Call (720) 918-0220